전체상품목록 바로가기

본문 바로가기


 

Post-curing is required in order to obtain the final material properties. After 3D printing in photopolymer resin-based materials is not yet fully cured. Post-curing is necessary to reach full monomer conversion for a various purpose.

CureM is outfitted with a automatic rotating table so that the optimum UV light can be reached the 3D objects. And it can reduce curing times with high capacity UV light source compared to other curing units and achieve more higher curing quality. And by attaching the high penetration LENS with narrow angle, UV light is much more focusing to 3D objects without loss of it.

 The illumination composition of 3 dimension
and inside reflector.
It can allow 3D objects to obtain more high
curing quality.

 To increase a intensity of UV LED and reach more stronger LED energy to the objects, it has attached narrow angle lens on the LED components.
It will be concentrated LED light on the objects and achieve the optimum curing quality.

Data sheet of UV LED

◎ Relative Spectral Power Distribution

◎ Maintenance of UV LED for the optimum intensity

To indicate the time used Right/Left/Upper UV LED on TFT LCD.
It will be required UV LED exceeding the standard using time to exchange for maintaining the best UV intensity.

◎ Certification